i-CON VARIO 2, multichannel 200W soldering and desoldering station (0ICV203AP), antistatic with integrated vacuum pump and serial interface:
- Mains voltage: 230 VAC;
- Secondary voltage 24 VAC;
- Max power 200W;
- Temperature range 150 – 450 °C;
- i-Tool AIR S temperature range 50 – 550 °C;
- Temperature regulation (at idle) < ± 2 °C;
- Ohmic resistance between soldering tip and ground < 2 Ohm;
- Integrated Vacuum pump, Vacuum 700 mbar max;
- Internal air flow generation: 2 – 20 l/min. The used air volume is metered out precisely and can be read off at the display of I-CON VARIO;
- Control technology SENSOTRONIC (PID-behaviour);
- Function display LC-Display, blue;
- Single-knob control via incremental encoder (i-OP);
-Antistatic.
Two tools operable at the same time. Connectable soldering/desoldering tools:
- Left side: i-Tool, Chip Tool VARIO, Power-Tool, Tech-tool, Micro-Tool, Chip-Tool, X-Tool and X-Tool VARIO;
- Right side: i-Tool AIR S or i-Tool HIGH POWER;
i-Tool AIR S hot air soldering iron (0470BRJ) with hot air nozzle 0472BR. Air volume can simply be set at the hand piece:
- Operating Voltage 24 VAC;
- Heating power 200W;
- Weight (without supply line) approx. 90 g;
- Antistatic;
- Motion sensor activates the i-Tool AIR S, and with its IR sensor mounted in the hand piece, it has an auto on/off function.
0A55 antistatic holder.
X-Tool VARIO desoldering device (0740EDJ):
- Voltage: 24 V~;
- Power rating: 150 W;
- Heat up time: 30 s, approx;
- Weight (incl. cable and tip): approx. 210 g;
- Temperature measurement: Ni-CrNi thermocouple;
- Starting vacuum: up to 700 mbar;
- Design: antistatic
Antistatic tool holder 0A56.